90° Tee, 4 pieces, anodized 6061-T6 aluminum
Requires 2x M3 Thumb Screws per 90° Tee, not included
Can be used to hold 3mm rod at 90° to each other. Screw one end of the 90° Tee on a 3mm rod and use one of the 3mm holes in the 90° Tee to hold a jumper wire on a pin.
Cast base, 140mm x 200mm, approximately 1Kg, textured finish This base is the foundation of the PCBGRIP system. The hole in the middle is threaded M10x1.5. The hole nearest the...
Clamp, 2 Pieces, anodized 6061-T6 aluminum, with stainless steel plate Requires ⌀3mm rod and 8x M3x0.5 Thumb Screws, not included. These clamps have 16 grooves at 2.54mm (0.1") spacing on one...