Electroplated steel gooseneck, 5mm in diameter, 200mm in length.
These goosenecks literally provide more flexibility in helping you work on your electronics project. One end of the gooseneck has M3x0.5x7mm male threads, while the other end has M3x0.5x8mm female threads. The standard M3x0.5 threads allow the goosenecks to be used with the PCBGRIP system. The goosenecks will support 100 grams and are fairly obedient (gooseneck talk for they stay put after you bend them). When used with the PCBGRIP system, the goosenecks provide 'helping hand' functionality for those hard to hold parts, while at the same time allowing you to rotate, twist, tilt, and raise the work.
90° Tee, 4 pieces, anodized 6061-T6 aluminum Requires 2x M3 Thumb Screws per 90° Tee, not included Can be used to hold 3mm rod at 90° to each other. Screw...
Cast base, 140mm x 200mm, approximately 1Kg, textured finish This base is the foundation of the PCBGRIP system. The hole in the middle is threaded M10x1.5. The hole nearest the...