Hinge Assembly, anodized 6061-T6 aluminum, with brass and stainless steel hardware, spring loaded index pin. PTFE thrust washers and PTFE lined bronze bushing for smooth operation.
Provides four degrees of freedom while supporting your work. Designed to fit over a 10mm rod, the Hinge Assembly allows you to (i) raise/lower; (ii) rotate about the vertical axis; (iii), rotate about the horizontal axis, and (iv) tilt your work, providing full access.
90° Tee, 4 pieces, anodized 6061-T6 aluminum Requires 2x M3 Thumb Screws per 90° Tee, not included Can be used to hold 3mm rod at 90° to each other. Screw...
Cast base, 140mm x 200mm, approximately 1Kg, textured finish This base is the foundation of the PCBGRIP system. The hole in the middle is threaded M10x1.5. The hole nearest the...